Product description   

Completely tailored sticker kit for YAMAHA R15 V3 series consists of six which has been completely designed , manufactured and retail by us. It is printed on the high-gloss sticker sheet and die cut for a more precise application INSTALLATION INSTRUCTIONS OLD DECAL REMOVALUse a blow dryer or heat gun to heat older decals and help peel them off. For any remaining glue you can still heat up a bit and rub off or use goo gone, rubbing alcohol or any similar residue/glue remover. GRAPHICS KIT INSTALLATION INSTRUCTIONS:
Tools Needed: Squirt bottle with water, squeegee (old credit card works well), soft cloth and scissors, heat gun or blow dryer. Install in room temperature. Do not rush the install.  

Features

• Thoroughly clean all surfaces with soap and water and remove all old adhesive, dirt, lint, oils etc. Rinse well with plain water and dry with lint-free cloth. Use rubbing alcohol or Goo Gone for any residue of old adhesive. Heating up old adhesive also helps in removal. If you use Goo Gone make sure you clean your plastics again with soap and water.
• Before removing decal backing, hold decals up to to your vehicle to get a general idea of how the graphics should look and where all the pieces go.
• Wrap a soft, lint free cloth around your squeegee.
• Spray the plastic you are going to work on first with water. Coat the entire outside surface.
• Slowly peel the backing from the decal piece, and as you peel, spray light mist of water to the adhesive side of the decal.
• Lightly set the decal onto the plastic making sure everything lines up properly. Start at one end of the decal and squeegee the water out of the other end.
• Use heat just enough to soften the vinyl for intricate curves. When using a heat gun or blow dryer be careful not to burn the kit.